Recently a customer from Australia contacted us for a very special project. He wanted us to design and fabricate a plenum for an AT Power throttle body on a custom built twin turbo Porsche 930. We gladly accepted and set to work. We approached this project as an opportunity to showcase our engineering and fabrication abilities, making this part as a two-piece machined component.

The design was based on the throttle body drawings provided by our customer, and as you can see the results are beautiful.  All that remain for the plenum to be completed is adding the throttle body inlet port and cross-over tubes, but it won’t be long until this beauty arrives in Australia.

C.Ramos – Design Engineer